This project is a model of a 2-spool high bypass turbofan. The whole engine is designed from scratch with visual reference from existing engines. For example, Rolls-Royce makes the best-looking fans, so there’s some resemblance there…

This is a 3D printable Handle using specified collet clamping system. useful for any deburring work like holes or re-drill some holes manually. 12 different diameter available and one collet for holding 1/4inch (6.35mm) bits.

This project is a lightweight and longrange FPV drone. It is based on the currently lightest available Whoop AIO board which need to be used due to its smaller form factor. The build is a bit more difficult as you need to solder! Moreover, the solder pads are quite small so you need a steady hand.

This is a wrist mounted repeating crossbow that fires empty pen cartridges from Pilot G2 and Frixon pens. Printable ammo types are also included however only the blunt ones will be available on Thingiverse in order to follow their community guidelines.

This is a project to make a beautiful illuminated alphabet. The letters are made of PLA and the LEDs are WS2812B RGB LEDs. The letters are connected to a Wemos D1 Mini V3.0.0.